6069 - [CrossLink-NX] MIPI: What is the time required for the MIPI D-PHY to resume after the power-down mode is de-activated?
The maximum PLL lock time is 5,000 input cycles.
Related Articles
6504 - Crosslink-NX: How can I achieve 2.5Gbps per line for D-Phy TX?
Description: Crosslink-NX can supports 2.5Gbps per line, but when I started D-Phy TX version 1.70, the TX Line Rate per line is 160~1500 Mbps. Solution: In order for the 2.5 Gbps per lane to be supported, you need to change from Gear 8 to Gear 16. ...
6946 - What is the spec of 'sync_clk_i' of MIPI D-PHY Rx IP? Does the signal require to be in synced with any other clocks?
Description: Spec is given that 'sync_clk_i', or the 'Sync clock frequency', can support 24-200Mhz, and it is defaulted to 60Mhz, based on CSI-2/DSI D-PHY Rx IP Core IPUG 02081 document. 'syn_clk_i' does not need to synchronize with any clocks, and ...
7601 - Crosslink & MIPI D-PHY:
How do I deal when I update the MIPI virtual channel aggregation with the latest version, I got an issue with my hardware where I cannot get an image in the stream?
Solution: Please use the old version IP. We have tested it with the following IPs: RX v1.3 and TX v1.2. The design seems functional based on the first tests. At the time it was developed sometime in 2019, using Hard D-PHY RX might cause simulation ...
5578 - CrossLink: Can Hard D-PHY blocks be configured for more than 4 lanes?
Description: This FAQ explains why Hard D-PHY blocks cannot be configured for more than 4 lanes in CrossLink product. Solution: In CrossLink product, there are 2x 4-lane D-PHY. Each of the 4-lane D-PHY runs on its own clock and has its own clock ...
6798 - MIPI for CertusPro-NX/CrossLink-NX: What is the maximum CSI RX Bandwidth?
Please refer to aggregated bandwidth: CertusPro-NX: (softIP: sysIOx3 banks ==> 1.5Gbps 4lane x 3 ports ==> 18Gbps) Crosslink-NX: (hardIP: 2 ports ==> 2.5Gbps 4lane x 2 ports ==> 20Gbps) + softIP ==> (total 38Gbps)