5867 - ispMach400: In BSDL file, if any IOs are configured as "Input Only"; Does the device needs to be erased and re-programmed to bi-directional pin the same as the output?

• Related Articles

• 7312 - Crosslink: How to implement OPENDRAIN on Bi-Directional I/O port in CrossLink device?

  CrossLink I/O does not have OPENDRAIN support for bi-directional pins. This feature is limited by the device hardware itself. However, this product still offers OPENDRAIN support but only limited to output ports only.

• 2453 - LatticeXP2: What does the I/O Type in Table 14-1 of TN1141 mean? For example, is the INITN pin only used as a bi-directional pin when CFG0 is high?<q1><q2></q2></q1>

  The I/O Type in Table 14-1 of TN1141 is for all the sysCONFIG pins during configuration. For the dual-purpose sysCONFIG pins, when they are used as general purpose I/Os after configuration, they can use any I/O type such as input, output and ...

• 7211 - Why is PULLMODE set to NONE when port is configured as output?

  Description: There is no PULLMODE for output-only ports, therefore all output pins PULLMODE will be fixed to 'NONE' in the tool. For bi-directional pins, PULLMODE will be relevant, and thus it will be set to 'NONE' when the bi-directional pin acts as ...

• 3881 - Is it possible with the signal 'ENABLE_OUTPUT' of the primitive SB_IO (IO primitive of the iCE40) to create a bi-directional Low Voltage Differential Signalling (LVDS) IO?

  No. the signal 'ENABLE_OUTPUT' of the primitive SB_IO (IO primitive of the iCE40) cannot be used to create a bi-directional LVDS IO. One has to use two separate pairs of IOs for LVDS Tx and LVDS Rx.

• 6161 - iCE40 UltraPlus: How utilize Differential Input pairs on an iCE40 device?

  For iCEcube2 compatible devices (LP/HX/LM/Ultra/UltraLite/UltraPlus), the user needs to use the SB_IO primitive and override the IO_STANDARD parameter to SB_LVDS_INPUT as shown in the rudimentary example below: SB_IO SB_IO_inst ( ...