5762 - Radiant/Diamond Programmer: Why did some added Custom Flash devices in programmer do not work?

• Related Articles

• 3035 - Lattice Diamond Programmer: How can I use a SPI Flash Memory although it's not included in the supported list of Serial Peripheral Interface (SPI) Flash devices in the Lattice Diamond programmer?

  Follow the below steps to add custom SPI flash in the Diamond Programmer: -Open the Lattice Diamond Programmer. -Go to Edit-->Custom devices. -Click "Add" to customize your actual device according to the datasheet of the flash. For more information ...

• 2404 - Lattice Diamond Programmer isn't listing a new SPI Flash device I would like to use, is there a work around?

  Even though Lattice Diamond Programmer doesn't appear to list the new SPI Flash device, it may still be found in the SPI FLASH OPTIONS category, under the FAMILY selection of SPI SERIAL FLASH BETA. If the user still does not see the new SPI Flash ...

• Lattice Diamond Programmer: Are there any differences in Flash programming algorithm of MT25QL512 if we change the package type in Diamond Programmer?

  The quick answer is that there are no differences. Assuming you have Diamond 3.11 installed, you may check this default location "C:\lscc\diamond\3.11_x64\data\vmdata\database\flash". This is where the actual flash algorithms used by the programmer ...

• 4015 - Diamond Programmer: Does the Diamond Programmer allow parallel programming on custom address ports?

  The Detect cable button in Diamond Programmer detects the cable only on the default parallel cable addresses (0x0378, 0x0278 and 0x03BC). It cannot be used to detect the custom address. Instead, setup your device with a custom port address and then ...

• Lattice Diamond and Radiant Programmer: Does Lattice Programmer software and driver support FT4232HQ?

  Both Lattice Diamond and Radiant Programmer are not support FT4232HQ.