5750 - Diamond: Is there other way to verify the Diamond Installation History aside from the History tab?

• Related Articles

• 7065 - How can user uninstall any patch from their Diamond/Radiant SW installation?

  There is no way to uninstall patches. The only way to remove patches is to start from a fresh installation of Diamond/Radiant version. In order to prevent the fresh installation from messing up the current installation with patches, user can install ...

• 7733 - ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...

• 1043 - Diamond / Installation: How to manually update ispLEVER and Diamond software?

  Solution: This describes how to manually update your software by using ispUpdate. For Lattice Diamond software, the "Update Center" is in the middle of your startup screen and will provide the most recent updates, if available. To manually check for ...

• 6526 - Lattice Diamond: Why do I encounter an installation error when installing Diamond Programmer_Encryption_Security pack?

  Description: When a user install the Diamond Programmer encryption security pack an error (sample error shown below) is encountered: "Unable to install Diamond Programmer_Encryption_Security 3.12.1.454.2. The Diamond Programmer version 3.12 ...

• 1030 - ispLEVER Classic / Installation: How to run ispLEVER tools on Windows 7 32-bit versions?

  Solution: ispLEVER is not supported to run on Windows 7 operating system. Based on our initial tests, we were able to run ispLEVER in the command line mode without any or minimal issues. ispLEVER is not fully compatible with Windows 7 when running in ...