5691 - Crosslink / CSI-2/DSI D-PHY Transmitter IP Core : For Crosslink, how can I get the register value from the display(destination)?

• Related Articles

• 7265 - MIPI CSI-2 / DSI D-PHY Transmitter: What is 'Counter Width' parameter in rx_dphy IP and how to calculate the value?

  Details: 'Counter Width' refers to bus width of the counter that tracks the number of rows written during the high-speed data transition. Setting the value for Counter Width is valid only when RX_FIO type is set to 'QUEUE' where high-speed data is ...

• 5389 - CrossLink: Why does the generated VHDL code does not contain any ports for CSI2/DSI D-Phy Receiver IP?

  Description: CSI2/DSI D-Phy is a submodule IP. This only provides an instantiation templates for vhdl because it is expected that it will be used in a larger design. In addition, generating this IP is done in Verilog.

• 5919 - MIPI D-PHY to CMOS Interface Bridge Soft IP: Why do I get this error message like this: "ERROR - IO register/latch csi2_to_cmos_inst/inst1_inst/lv_ff cannot be implemented in PIC."?

  Description: This is caused by forcing a register whose input is being traced to be implemented as an input flip-flop because of a preference, USE DIN. Solution: The user should allow the register to be implemented as an internal flip-flop by ...

• 6946 - What is the spec of 'sync_clk_i' of MIPI D-PHY Rx IP? Does the signal require to be in synced with any other clocks?

  Description: Spec is given that 'sync_clk_i', or the 'Sync clock frequency', can support 24-200Mhz, and it is defaulted to 60Mhz, based on CSI-2/DSI D-PHY Rx IP Core IPUG 02081 document. 'syn_clk_i' does not need to synchronize with any clocks, and ...

• 5923 - MIPI D-PHY to CMOS Interface Bridge Soft IP: Can the DSI to CMOS IP be changed to DPHY1 from DPHY0?

  The user can change the hardened D-PHY blocks location between DPHY0 and DPHY1 by adding a LOCATE preference in the .lpf file to SITE "MIPIDPHY0" or SITE "MIPIDPHY1". The LOCATE preference is the following, for example: LOCATE COMP " ...