5664 - iCE40 Ultra/UltraLite: How to resolve "Failed in Function NVCM_ENABLE" error during programming?

• Related Articles

• 7118 - MachXO3D: Why does MachXO3D device flash programming operation failed with "ERROR - Failed in Function FLASH_ENABLE" when Password Protection was enabled?

  Description: After user enabled Password Protection feature in Diamond Programmer and program the passkey into MachXO3D device, user may experienced Flash Programming Mode operation failed with the following error message: ERROR - Failed in Function ...

• 5553 - Why in LCMXO2 part I got the following error message: ERROR - Failed in Function VERIFY_SRAM_DONE_BIT ?

  The "Failed in Function VERIFY_SRAM_DONE_BIT" means that, the Diamond Programmer is unable to determine the statue of the DONE bit in the device's Status Register. This could have happened due to following reasons: The DONE bit is NOT SET due to the ...

• 6003 - iCE40 Family: What are the most common causes of NVCM programming or configuration failures on iCE40 Devices?

  There are 3 common causes of NVCM boot failure: 1. When NVCM programming is performed, Vpp_2V5 voltage limits have a smaller window and it should only be from 2.3V to 3,00V. 2. On some iCE40 devices such as iCE40 Ultra and iCE40 Ultraplus, there are ...

• 6460 - LatticeECP2/M: "ERROR - Failed in Function VERIFY_STATUS (see log file for more details)" - possible issue when trying to configure an FPGA using HW-USBN-2B?

  Description:Error message: ERROR -Failed in Function VERIFY_STATUS (see log file for more details) Solution:It is possible that the issue came from a microcontroller connected to the FPGA's PROGRAMN pin. This pin is intended to hold off the FPGA ...

• 7745 - Avant Rev 03x: Why program Quad SPI Flash Programming failed with JTAG2SPI Bridge

  Description User may experience Radiant Programmer fails to perform SPI flash programming via the JTAG2SPI bridge function on Avant Versa RevA Boards populated with Micron MT25QU512ABB8E12-0SIT (Quad) for Avant 03A silicon. There is no issue ...