5646 - ECP5/ECP5-5G/CrossLink: If the user wants to update the bitstream in the field and encrypt the bitstream so that it can only be used on my product, is there a solution available in the CrossLink device?  If yes, in what document is it stated?

• Related Articles

• 2514 - MachXO2/MachXO3: What is the best way to program a Lattice MachXO2 device in the field with minimum disruption?

  Solution: The Lattice MachXO2 devices can be updated in the field by utilizing Lattice's background programming mode and TransFR Technology Background programming: The on-chip flash can be programmed in background mode, while the device and IOs ...

• 6597 - Crosslink-NX: What is the boot-up time for the Crosslink NX device?

  In datasheet, it is mentioned that "Instant-on configuration – IO configures under 3 ms". The boot-up time is based on estimation with respect to the following parts: power ramp time, config Post Power-up Test (self-test and trimming) time, bitstream ...

• 6463 - CrossLink: Does Crosslink supports full background programming?

  The Crosslink did not support full background programming. It is only supporting partial background re-configuration using the SEI (Software Error Injection) or read-back features. The statement in the document means that if you persisted with the ...

• 681 - LatticeECP2: How to setup LatticeECP2 dual boot application to load the golden bitstream instead of primary bitstream?

  Description: A dual boot application using the LatticeECP2 device has both a golden bitstream act as the golden image, and a primary bitstream act as user image which is periodically updated in SPI Flash. In a typical dual boot configuration ...

• 2714 - ICE40: What are the programming modes available in LatticeiCE40 device?

  The LatticeiCE40 device has the following programming modes : SPI Master: In this mode, a standard SPI Flash is connected to the Device , and the device boots from the external SPI Flash using SPI Master configuration Interface. This is the best ...