5571 - Why do I need to migrate from ispPAC-POWR1208 to ispPAC-POWR1014A?

• Related Articles

• 5576 - Do I need a modified the FTDI firmware If I'm going to build a custom board similar to Lattice's evaluation boards?

  You don’t need any firmware for the FTDI chip as long as you keep the default FTDI ID.

• 6859 - What do user need to do or consider to make the 16-bit counter project work for the AVANT Evaluation board?

  Two things to check/do to make the 16-bit counter project work for the AVANT Evaluation board: 1. The 16-bit counter project does not have port assignments on the PDC file for the AVANT Evaluation board. User need to assign the reset_n port of the ...

• 5987 - Platform Manager 2: What is the ISPPAC-POWR1220AT8-01T100I junction to case resistance?

  The Lattice Thermal Management document provides these details and can be found here: http://www.latticesemi.com/view_document?document_id=210 Page. 9, Table 3.1 gives the package data for the TQFP 100, 1.4mm for Package Thermal Resistance

• 2855 - Power Manager II: Do I need to connect a 100 ohm series resistor between monitored voltages and VMON pins on the POWR1220AT8 device?

  No, you can connect the VMON pins directly to monitored voltages which are between 0 and 5.9V. Some of the Lattice evaluation board schematics do include a resistor between the monitored voltage and the VMON pins. This is typically only used with the ...

• 2944 - Will the "PRIVATE" instructions in BSDL file have any impact on my BSCAN test? Do I need them to perform a BSCAN test?

  The "PRIVATE" instruction will not prevent one from doing BSCAN test. The public instructions provided by Lattice have perfectly met IEEE standard for BSCAN . These "PRIVATE" instructions are for our company internal use. There will not be any ...