5544 - Diamond/CrossLink: Why did I encounter missing Ack for the last Byte when programming Crosslink device via I2C on LIF-MD6000 MasterLink board?

• Related Articles

• 7733 - ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...

• 1781 - MachXO2: Does ispVM System support programming a Lattice MachXO2 via its Slave SPI port?

  Yes, beginning with the Lattice Diamond 1.2 release, the ispVM System programmer tool supports programming the Lattice MachXO2 device via the Slave SPI port using a standard Lattice Programming cable. Connect the programming cable to the XO2 SPI pins ...

• 5414 - iCEcube2: Why the "Adept USB Programming Software" mentioned in iCEblink40LP1KEvaluationKitUsersGuide.PDF is missing?

  Description: The iCEBlink boards were designed when we supported the bundled iCE programmer. Current versions of iCECube2 do not support iCE programmer. Also with the latest Diamond programmer, USB support for programming the board is not available. ...

• 6071 - CrossLink: Why did I get 0x7F for a device ID instead of 0x15 when attempting to prgoram the SPI flash on MasterLink Board?

  Please try to use custom clock divider and try to set a certain value, for example, 5. After setting correct configuration, you should be able to arrive on the same output that I get which should succeed operation. It appears that by using default ...

• 7014 - Radiant Programmer: Does Radiant Programmer supports XCF file creation and automate programming via Linux OS?

  We currently do not have TCL commands that support creating *.xcf file from scratch that will then be used by Radiant programmer. XCF creation can only be done through Programmer GUI. You could use the PGRCMD command to run the programmer which also ...