5520 - XP2: What to do when customer is using Keysight HP3070 for isp programming of Lattice XP2 but we need to comply to DO254?

• Related Articles

• 5727 - Programmer: Does the customer-made FT2232H-based programmer supported by the Lattice Diamond Programmer software?

  Lattice is using FTDI chip or FT2232H, therefore technically, the Lattice Diamond Programmer should recognize the available customer-made FT2232H based-hardware. By using Lattice Diamond Programmer Software, you can read and program the device the ...

• 1781 - MachXO2: Does ispVM System support programming a Lattice MachXO2 via its Slave SPI port?

  Yes, beginning with the Lattice Diamond 1.2 release, the ispVM System programmer tool supports programming the Lattice MachXO2 device via the Slave SPI port using a standard Lattice Programming cable. Connect the programming cable to the XO2 SPI pins ...

• 456 - ispVM System: Does Lattice support the programming of SPI FLASH memory via the JTAG port using ispVM System?

  Yes, ispVM Embedded does support the programming of SPI FLASH memory via the JTAG port. Refer to the ispVM Embedded.pdf document that is located in your ispLEVER installation directory under: ...\ispvmsystem\documents\application notes

• 7087 - Radiant Programmer: Does this support remote programming capability?

  Radiant Programmer itself does not have the capability of doing remote programming, it will need a third-party connection to allow remote programming. User can use their server as long as they have the 3rd party hardware component (hub) and software ...

• 747 - Lattice ispVM: Can Turbo mode be used together with background programming or TransFR?

  Yes, Turbo ispDOWNLOAD mode can be used together with the background programming and TransFR modes. Background programming mode is when the device being programmed in the background. This implies that the device is working and functioning as in ...