451 - PAC-Designer 5.2: Why does the tool fails to run and issues the following message? "C:\PAC-Designer52\PACD52.exe. This application has failed to start because the application configuration is incorrect. Reinstalling the application may fix the probl

• Related Articles

• 1853 - PAC Designer: What does the error message “The application has failed to start because the application configuration is incorrect. Reinstalling the application may fix this problem” mean when launching PAC Designer?

  This error message typically occurs when a user does not have Microsoft's .NET framework set up correctly for their machine. The necessary components are also provided with PAC-Designer, and can be manually installed by running the file ...

• 2310 - PAC-Designer:  Why does my POWR1014A design fail to compile but not give an error message?

  If your Power Manager II design fails to compile and gives no error message it could be due to the use of periods or spaces in the project file name or the path name. Usually the failure message is produced immediately after starting the compile ...

• 2363 - PAC-Designer:&nbsp; Why does user design fail to compile with a Warning 1211: Generate NAF file failed?<br>

  If the user Power Manager II design fails to compile and gives a Warning 1211 in the error message window it may be caused by using spaces or periods in the project file name or path name. AHDL2BLF; ABEL-HDL Processor PAC-Designer 6.30 Copyright(C), ...

• 1467 - PAC-Designer:&nbsp;How can I set up the simulation time in PAC Designer ?

  PAC-Designer: To simulate a design with Lattice Logic Simulator, the design must first be entered or edited using both the schematic windows and the LogiBuilder Sequence Editor. Next, a stimulus file should be created or edited using the Waveform ...

• 651 - PAC-Designer: Why does my LogiBuilder design fail to compile?&nbsp;&nbsp;<strong>PAC-Designer</strong> fails with: F38009 Invalid Node assignment for signal 'pin assignment'.

  PAC-Designer: PAC-Designer will issue this error message if an output is set to be controlled by I2C and that same output is used in a Boolean equation. The fitter drops the output macrocell from the resource list as I2C is controlling the pin. ...