406 - Where is the Reset pin for the Power Manager II - POW607 ?

• Related Articles

• 1666 - Power Manager II: Can I use the RESETb pin on a POWR1014 or POWR1220 to reset other parts of my circuit?

  The RESETb pin on an ispPAC-POWR1014 or ispPAC-POWR1220 is bidirectional (open drain with internal pull-up). Its primary function is to be used as an input so that one can reset the device after it has been powered up. The secondary function of this ...

• 405 - Does the VCCPROG pin have to be powered to program the Power Manager II - POWR1220AT8?

  The VCCPROG pin only needs power if the POWR1220AT8 is going to be programmed in circuit with the rest of the board powered down. This pin is provided as a programming option and should not be powered up when VCCD and VCCA are powered up. The ...

• 1997 - Power Manager II: What is the buffer type for the POWR1220AT8 JTAG TDO pin and what voltage should the pull-up resistor be tied to for this pin?<br>

  The JTAG TDO pin is an LVCMOS output that is referenced to the voltage applied to the VCCJ pin. The voltage reference for this pin is shown in note 1 to the Digital Specifications table on page 1-11 of the ispPAC-POWR1220AT8 data sheet. There is no ...

• 2521 - Power ManagerII: Where can I find the process technology information for the Power Manager II products?

  Solution:Lattice publishes a Product Family Qualification Summary for the Power Manager II products, found on our website at this link: Power Manager Qualification Summary. This document provides details on the qualification process and results for ...

• 433 - How can I sense current with a Power Manager II?

  The Power Manager II devices can not measure current directly. However, the Application Note AN6049 shows several circuits that can be used with a Power Manager II device to measure current. The circuits shown convert the current into a voltage that ...