4030 - ispLever Classic: Is ispLever classic supported on Linux or Mac OS X platforms?

• Related Articles

• 7280 - ispLever Classic 2.1: Is it supported on Windows 11?

  Answer: No, ispLever Classic 2.1 is not officially supported on Windows 11. A compatibility service pack was released for Windows 10, but there is no roadmap or planned update for Windows 11 support. This is because most devices used with ispLever ...

• 1030 - ispLEVER Classic / Installation: How to run ispLEVER tools on Windows 7 32-bit versions?

  Solution: ispLEVER is not supported to run on Windows 7 operating system. Based on our initial tests, we were able to run ispLEVER in the command line mode without any or minimal issues. ispLEVER is not fully compatible with Windows 7 when running in ...

• 7461 - ispLever Classic 2.1: Why is the "PULL" option of ispLever Classic not editable for designs using ispMACH 4000V/B/C/Z device?

  When creating a design in ispLever Classic using ispMACH 4000V/B/C/Z devices, the "PULL" constraint option cannot be edited individually for each I/O and is greyed out. For the ispMACH 4000V/B/C/Z devices, the "PULL" constraint can only be edited on ...

• 712 - ispLEVER Classic: What are the things that can prevent ispLEVER Starter from installing correctly?

  Solution: Due to the differences in hardware and software, there are differing reasons why the Lattice ispLEVER Starter software may have problems installing. Below is a list of things to check and try when diagnosing an ispLEVER installation ...

• 1031 - ispLEVER Classic / Installation: Does the tool can be installed in 64-bit Windows 7 or 64-bit Windows Vista?

  Solution: No, it does not. The ispLEVER is not supported for 64-bit Windows 7 or 64-bit Windows Vista. This FAQ is intended to help facilitate running ispLever on one of these two operating systems. ispLEVER is fully supported in 32-bit Windows XP ...