3760 - Programmer: How to reduce the TCK frequency on JTAG port while configuring a device through TCL Console?<br>

• Related Articles

• 974 - ispVM: How does ispVM tool control the TCK duty cycle and/or frequency?

  The actual TCK frequency has dependency on factors such as PC speed, parallel port vs. USB cable, USB 1.1 vs. 2.0 etc. Under ispVM Project -> Project Settings, Advanced, user may use the TCK Low Pulse Width Delay option to slow down the TCK. This ...

• 1226 - Radiant Programmer: What programmer detected Lattice device as "JTAG-NOP"?

  JTAP-NOP indicates that a device was detected, but its JTAG IDCODE is not available in software device database. There are a few reasons this may occur: 1. The device is a newer Lattice device and is not yet supported by the software tool version ...

• 605 - Lattice ispVM: Can ispVM control the JTAG TCK duty cycle and/or frequency?

  The ispVM software only provides a way to control the length of the low pulse of the clock. You can change the duration of the low pulse using the ispVM Project->Project Settings dialog and clicking on the Advanced button. Using the TCK Low Pulse ...

• 2119 - How can I&nbsp;use Test Access Port (TAP) Instructions for a Power Manager Device&nbsp;?

  Solution: In a Power Manager Device an IEEE 1149.1 test access port (TAP) provides the control interface for serially accessing the digital I/O of the device. The TAP controller is state machine driven with mode and clock inputs. Given in the correct ...

• Lattice Diamond Programmer: Do JTAG Full VME embedded source files are supporting JTAG Daisy Chain Programming?

  The answer is yes, JTAG Full VME embedded source files are supporting the JTAG Daisy Chain Programming. The chain of devices setup should be done in the Lattice Diamond Programmer file (.xcf) by adding target device/s.