3659 - LatticeXP2: Please explain how the "DONE_EX" preference works?

• Related Articles

• 6827 - Diamond: How to add falling clock to INPUT_SETUP constraint/preference in Diamond?

  1. Try using Synplify Pro as the synthesis tool and migrate your LDC file to an SDC file (please put the correct names of the clock, ports, nets, and pins as these might change when changing synthesis tool.) 2. Use INPUT_SETUP preference. This has ...

• 1142 - ispVM: How to generate a LatticeXP and LatticeXP2 device bit file for EPROM programming?

  Unlike using bitstream file *.bit like LatticeSC or LatticeECP3 family, LatticeXP and LatticeXP2 have JEDEC file output format for programming. When using ispVM to program device through JTAG interface, there is no extra step. But to program a EPROM, ...

• 295 - Lattice Diamond: How do I generate a LatticeXP and LatticeXP2 device bit files for EPROM programming?

  Unlike the SRAM based FPGA families like LatticeECPx and LatticeSC, the programming bitstream file for the Flash based LatticeXP and LatticeXP2 are JEDEC file format. When using ispVM to program the on-chip Flash through the JTAG interface, the JEDEC ...

• 1871 - LatticeXP2: Can the PROGRAMn and DONE pins be used as general purpose input/output?

  The PROGRAMn and DONE pins on the LatticeXP2 can be either dedicated for device configuration, or they can become General Purpose I/O (GPIO). The CFG0 input pin to the FPGA controls how these pins behave. You can find full details in LatticeXP2 ...

• 3837 - Lattice Diamond: Is the USE EDGE preference available in the tool for MachXO2 devices?

  Solution: The USE EDGE preference is not available for MachXO2 devices in Lattice Diamond software. The only way to support the edge is through the design - ECLKSYNC and DDR modules only.