3591 - How to measure board-related parameters, such as board dimension, mounting hole position, and mounting hole diameter?
To measure board-related parameters:
1. Download the board file from Lattice Semiconductor website.
Products -> Development Kits & Boards -> "Board Name" -> Downloads.
Note: "Board Name" is the board for which you want to download the board file.
2. Download and install a compatible tool for viewing the board file, for example Allegro Viewer.
3. Open the board files, use the measurement option, for example in case of Allegro Viewer use “Show measure” option.
With the above procedure most of the board-related parameters can be measured.
Related Articles
1747 - LatticeECP3: What are the mechanical positions of the mounting holes and J58 pin A1 on the LatticeECP3 IO Protocol Evaluation Board?
For the Rev C version of the LatticeECP3 IO Protocol evaluation board, the mounting hole positions are at: (0.000, 7.606) - upper left (3.460, 5.940) - upper center (7.606, 7.606) - upper right (0.000, 0.000) - lower left (5.000, 2.040) - lower ...
5598 - Where can I find the dimension for mounting holes on LIF-MD6000 evaluation board?
For the mechanical drawing of the LIF-MD600 MasterLink Board, please proceed on the link below. http://www.latticesemi.com/en/Products/DevelopmentBoardsAndKits/CrossLinkLIFMD6000MasterLinkBoard Under Documentation table, select 'Design File' under ...
7748 - Why is there a mismatch between the hardware checklist and the evaluation board circuit design?
Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...
3813 - What is the difference between solder ball diameter and solder ball land diameter in TN1074, PCB Layout Recommendations for BGA Packages?
Solder ball diameter refers to component/package ball diameter, and solder ball land diameter refers to PCB land diameter.
7030 - Crosslink-NX: Do you have any connector board which can be connected to the J12 of VVML board?
There's no available connector board for this.