2949 - Lattice Diamond Programmer: How can user view a VME file using Lattice Diamond software?

• Related Articles

• 5727 - Programmer: Does the customer-made FT2232H-based programmer supported by the Lattice Diamond Programmer software?

  Lattice is using FTDI chip or FT2232H, therefore technically, the Lattice Diamond Programmer should recognize the available customer-made FT2232H based-hardware. By using Lattice Diamond Programmer Software, you can read and program the device the ...

• 6143 - Lattice Diamond Programmer: Do JTAG Full VME embedded source files are supporting JTAG Daisy Chain Programming?

  The answer is yes, JTAG Full VME embedded source files are supporting the JTAG Daisy Chain Programming. The chain of devices setup should be done in the Lattice Diamond Programmer file (.xcf) by adding target device/s.

• 7733 - ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

  In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...

• 6185 - Lattice Diamond and Radiant Programmer: Does Lattice Programmer software and driver support FT4232HQ?

  Both Lattice Diamond and Radiant Programmer are not support FT4232HQ.

• 2378 - Diamond:  In Lattice Diamond, what is the difference between a Pin Layout File and a Pin Out file?

  A Pin Layout File is a report of pin information and assignments in your design. It is created from within the Lattice Diamond Spreadsheet View using File>Export Pin Layout File The Pin Layout File can be a list of available pins, pad names, ...