275 - PAC-Designer: How do I change the Timers on a ProcessorPM-PM605?

Solution:

The device is programmable and may change it if needed using PAC-Designer. By default, the shipped configuration is programmed to implement a Power Supply Supervisor, Reset Generator and Watchdog Timer. The timer functions for the watchdog have 2 pins that can be strapped to achieve 500ms, 2 sec, 10 sec, 1min. These are the WDT-Sel0, WDT-Sel1 pins. Pulse stretching timing is either "On" (200ms) or "Off" and this too is controlled by strapping a pin called stretch-200ms. http://www.latticesemi.com/products/powermanager/powermanagerii/processorpmpowr605/index.cfm?source=sidebar

Related Articles
2228 - PAC Designer: How to change the timer value when using an ABEL design?
When using an ABEL design for the Power Manager II devices, the XLAT_STIMER macro and the XLAT_PRESCALER macro are both only used for simulation. Changing these parameters will NOT affect the setting of the timers in the Power Manager II device ...
1895 - PAC Designer: How to change the I2C Address of the ISPPAC1014A device using the I2C Utility within PAC-Designer?
Users cannot change the I2C address of the POWR1014A using the I2C utility. This only sets the address that gets used by the utility to communicate to the POWR1014A. The I2C address for the POWR1014A device is specified using the schematic sheet of ...
273 - PAC Designer: How to simulate a design with ProcessorPM-POWR605 device?
The following link provides information for Reference Design RD1056, titled "Watch-dog Timer and Reset Generation with ProcessorPM". The link has the documentation and the source code for the design that is pre-programmed into the ProcessorPM. The ...
831 - PAC-Designer: How do I convert my Logi-Builder design code to ABEL?
PAC-Designer: There are times when the user wants to convert the design to ABEL language to describe the sequence for a Power Manager. Start a simple sequence and add your timers and output states in LogiBuilder. Save the design Compile the design ...
2358 - PAC-Designer:  An output pin in the PAC-Designer project is now assigned as a node. Why did it change and how can the user change it back to an output?
The PAC-Designer Logibuilder software should not assign an output as a node, this is an issue in earlier versions of the software. A PAC-Designer project with this assignment is corrupted and cannot be fixed inside PAC-Designer. Recommendation is to ...

275 - PAC-Designer: How do I change the Timers on a ProcessorPM-PM605?

275 - PAC-Designer: How do I change the Timers on a ProcessorPM-PM605?

Related Articles

2228 - PAC Designer: How to change the timer value when using an ABEL design?

1895 - PAC Designer: How to change the I2C Address of the ISPPAC1014A device using the I2C Utility within PAC-Designer?

273 - PAC Designer: How to simulate a design with ProcessorPM-POWR605 device?

831 - PAC-Designer: How do I convert my Logi-Builder design code to ABEL?

2358 - PAC-Designer:&nbsp; An output pin in the PAC-Designer project is now assigned as a node. Why did it change and how can the user change it back to an output?

2358 - PAC-Designer: An output pin in the PAC-Designer project is now assigned as a node. Why did it change and how can the user change it back to an output?