273 - PAC Designer: How to simulate a design with ProcessorPM-POWR605 device?

• Related Articles

• 1895 - PAC Designer: How to change the I2C Address of the ISPPAC1014A device using the I2C Utility within PAC-Designer?

  Users cannot change the I2C address of the POWR1014A using the I2C utility. This only sets the address that gets used by the utility to communicate to the POWR1014A. The I2C address for the POWR1014A device is specified using the schematic sheet of ...

• 2228 - PAC Designer: How to change the timer value when using an ABEL design?

  When using an ABEL design for the Power Manager II devices, the XLAT_STIMER macro and the XLAT_PRESCALER macro are both only used for simulation. Changing these parameters will NOT affect the setting of the timers in the Power Manager II device ...

• 1490 - PAC-Designer: How do PAC-Designer's project archiving functions work?

  PAC-Designer: It is often necessary to send a PAC-Designer design to a colleague, or save it in a revision database. Some device types, such as the Power Manager product families contain multiple files. To aid in organizing these files, PAC-Designer ...

• 1467 - PAC-Designer: How can I set up the simulation time in PAC Designer ?

  PAC-Designer: To simulate a design with Lattice Logic Simulator, the design must first be entered or edited using both the schematic windows and the LogiBuilder Sequence Editor. Next, a stimulus file should be created or edited using the Waveform ...

• 275 - PAC-Designer: How do I change the Timers on a ProcessorPM-PM605?

  Solution: The device is programmable and may change it if needed using PAC-Designer. By default, the shipped configuration is programmed to implement a Power Supply Supervisor, Reset Generator and Watchdog Timer. The timer functions for the watchdog ...