2578 - PAC Designer: When using the File->Import command in PAC-Designer, what information is imported from the JEDEC file?

• Related Articles

• 1895 - PAC Designer: How to change the I2C Address of the ISPPAC1014A device using the I2C Utility within PAC-Designer?

  Users cannot change the I2C address of the POWR1014A using the I2C utility. This only sets the address that gets used by the utility to communicate to the POWR1014A. The I2C address for the POWR1014A device is specified using the schematic sheet of ...

• 2363 - PAC-Designer:&nbsp; Why does user design fail to compile with a Warning 1211: Generate NAF file failed?<br>

  If the user Power Manager II design fails to compile and gives a Warning 1211 in the error message window it may be caused by using spaces or periods in the project file name or path name. AHDL2BLF; ABEL-HDL Processor PAC-Designer 6.30 Copyright(C), ...

• 830 - PAC-Designer: What is the best way to get started on using Lattice PAC-Designer Mixed Signal Software?

  PAC-Designer: Is there an easy way to get started learning Power-Manager Devices and PAC-Designer? The first step is to download PAC-Designer from the web. The next step is to take a look at the example file directory. Use FILE, DESIGN EXAMPLES. This ...

• 2573 - PAC Designer: How does the DC-DC Converter library work with the TRIM resistor calculation in PAC-Designer when a project is opened but does not have access to the original DC-DC Converter library?

  Solution: When a user creates a new item in the DC-DC Converter library an .XML file is created and saved in the "PAC-Designer\DCtoDC_Library" folder. Then when the user configures each Trim output, they must Import a DC-DC converter into the design ...

• 1467 - PAC-Designer:&nbsp;How can I set up the simulation time in PAC Designer ?

  PAC-Designer: To simulate a design with Lattice Logic Simulator, the design must first be entered or edited using both the schematic windows and the LogiBuilder Sequence Editor. Next, a stimulus file should be created or edited using the Waveform ...