2391 - LatticeECP3: Please provide pre-emphasis characteristics data for LatticeECP3 SERDES.

• Related Articles

• 355 - What's the best, first step to debug looped-back 16-bit data with 8b10b encoding for SERDES/PCS applications in Lattice FPGA's?

  For this type of SERDES application, the 8-bit comma character will always occur in the same 8-bit word location in the 16-bit RX data, as long as the transmitter never sends back-to-back commas or sends commas that are an odd number of cycles apart. ...

• 766 - SERDES can run at either full-data-rate mode or half-data-rate mode What is the difference between the two?

  With the same reference clock frequency, if the SERDES is configured to half-data-rate mode, the SERDES data rate is only half of the data rate supported in the full-data-rate mode. It is useful when different rates are used for different channels in ...

• 1179 - When using the Lattice FPGA PCS/SERDES QUADS in 10-bit Raw SERDES mode, how do I do interpret the 10-bit 8b10 encoded RX DATA?

  The response applies to the LatticeECP2M/LatticeECP3/LatticeSC/M PCS/SERDES QUADS used in 10-bit RAW SERDES only mode. The assumption is that you are coding your own RTL 8b10b decoder in the fabric. Based on the definition of 8b10b codes , DATA=0x00 ...

• 6965 - Serdes/PCS: How to know if the two SerDes data rates can be generated with the same reference clock frequency?

  Description: From FPGA-TN-02245-1-1-CertusPro-NX-SerDes-PCS-User-Guide of the Appendix C. Calculating Parameters for SerDes PLL, it shows the available data rates with respect to the reference clock. However in any case that the desired data rate for ...

• 2722 - SERDES/ECP3:Why do I receive data errors when I configure the LatticeECP3 SERDES/PCS in TX-to-RX Serial Loopback Mode?

  The TX-to-RX Serial Loopback Mode is supported in the LatticeECP3 device (see "Control Setup" and "TX-to-RX Serial Loopback Mode" sections of FPGA-TN-02190). In this loopback test mode, the TX output serial data is looped back into the RX SERDES CDR. ...