2389 - Do BLOCK constraints limit the maximum coverage % reported in the timing report that can be achieved (<100%)?

• Related Articles

• Lattice Radiant: How do I achieve 100% timing coverage?

  To achieve 100% timing coverage, you must define the following constraints: 1) create_clock constraint on all your clock ports 2) create_generate_clocks on all nets/pins/ports 3) set_input_delay and set_output_delay on your input and output ports. ...

• Radiant: How does the user interpret the Single Clock Domain table entries on the Clock Summary section of the Place & Route Timing Analysis Report?

  The Single Clock Domain table of the Clock Summary Section of the Place & Route Timing Analysis report: There are three values on this table: 1. The Target is the frequency or period based on the clock constraint. This should always be the lowest of ...

• 740 - Lattice ispLEVER: Timing Analysis: What is the I/O Timing Report?

  Lattice ispLEVER: Timing Analysis: The I/O Timing Report (.ior) is a used to report the IO timing analysis of your design. Input Setup and Hold times (Tsu, Th) and Clock-to-Output times (Tco) are reported. The IO Timing Report sweeps across all the ...

• 938 - Timing: What is the I/O Timing Report?

  Timing: The I/O Timing Report is a used to analyze the the IO timing in your design (Tsu, Th, Tco). The IO Timing Report sweeps across all the speed grades to determine the worst case.

• 261 - Lattice Diamond: Why is the maximum frequency Fmax in the Place and Route Trace report different from that in the Performance Analyst(PA) report?

  The Trace report determines the Fmax of a design taking into account all of the timing constraints in the projects preference file (i.e.*.lpf). For example, the preference file may have a multicycle constraint: MULTICYCLE FROM GROUP "START_WORD_REG" ...