2358 - PAC-Designer:  An output pin in the PAC-Designer project is now assigned as a node. Why did it change and how can the user change it back to an output?

• Related Articles

• 651 - PAC-Designer: Why does my LogiBuilder design fail to compile?&nbsp;&nbsp;<strong>PAC-Designer</strong> fails with: F38009 Invalid Node assignment for signal 'pin assignment'.

  PAC-Designer: PAC-Designer will issue this error message if an output is set to be controlled by I2C and that same output is used in a Boolean equation. The fitter drops the output macrocell from the resource list as I2C is controlling the pin. ...

• 2865 - PAC Designer: How to&nbsp;implement a&nbsp;latched&nbsp;output&nbsp;for the Power Manager Device?

  In the PAC-Designer Software, users can use D Flip-Flop to implement a clocked latch. In the Logibuilder section of the PAC-Designer software, declare a registered D Flip-flop output using Supervisory Equations. The registered output can be assigned ...

• 1446 - PAC-Designer: In PAC Designer software what does NODEx mean in Pin Definitions?

  PAC-Designer: NODEx are internal variables or registers and are not output pins. They can also be used to interact between different state machines. To access/rename an available node, keep Sequence and Supervisory Logic (CPLD) window active and ...

• 1490 - PAC-Designer:&nbsp;How do PAC-Designer's project archiving functions work?

  PAC-Designer: It is often necessary to send a PAC-Designer design to a colleague, or save it in a revision database. Some device types, such as the Power Manager product families contain multiple files. To aid in organizing these files, PAC-Designer ...

• 1895 - PAC Designer: How to change the I2C Address of the ISPPAC1014A device using the I2C Utility within PAC-Designer?

  Users cannot change the I2C address of the POWR1014A using the I2C utility. This only sets the address that gets used by the utility to communicate to the POWR1014A. The I2C address for the POWR1014A device is specified using the schematic sheet of ...