2243 - LatticeECP3: How can I get around the error "trace: Mangled ncd file before signal read"?

Description:

Lattice Diamond Timing Analysis tool (trace) outputs this error when it encountered NCD file that failed integrity check. Typically this is due to the file being corrupted. You can get around this issue by removing the NCD file and restarting the implementation flow.

Related Articles
7733 - ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?
In Diamond version 3.14, there is a bug where it incorrectly limits the number of PLLs in the device to 0 for LFE5U-12F. Example error message: ERROR - (device oversize error). The number of PLL components needed (1) exceeds the number available. ...
1915 - Diamond: ERROR - par: Failed to dump design to file.
The complete message for this error message is: ERROR - par: Failed to dump design to file <<FILE_PATH>/<FILE_NAME>.ncd> INTERNAL CODE : ncdesign:basncdesign:2244:2.13 In Diamond, when user performs PAR they might encounter this error message for ...
1193 - ispLEVER Classic / Installation: What to do if error pops out when starting ispLEVER Classic "Can't read the ini file."?
Description: At start up, ispLEVER looks for an initialization file that is normally located under the lsc_env file (which normally sits directly under the C: drive). If ispLEVER cannot find this file (e.g. C:\lsc_env\lsc_1_4.ini), then the user will ...
2692 - Reveal: How do I get further detail for the "Failed to read design" error message in Reveal Inserter?
When the design input is RTL, Reveal Inserter has to read or parse the design to provide the list of debug-able internal nodes. If it encounters errors, Reveal Inserter simply reports "Failed to read design". As Reveal Inserter uses the same parser ...
6822 - Lattice Diamond: Why does my design encounter a MAP error shown below when running the design flow?ERROR - <signal_name> matches no clock nets in the design.
Description: This is encountered if the signal is being defined (for example in constraint file) and that signal is optimized (or the net does not actually exist in the design) by the synthesis tool, To fix the error add in the following attribute to ...

2243 - LatticeECP3: How can I get around the error "trace: Mangled ncd file before signal read"?

2243 - LatticeECP3: How can I get around the error "trace: Mangled ncd file before signal read"?

Related Articles

7733 - ECP5 / Diamond 3.14: Why does my design get a Map device oversize error related to PLL for LFE5U-12F in with Diamond 3.14, but completes map successfully in earlier releases of Diamond software?

1915 - Diamond: ERROR - par: Failed to dump design to file.

1193 - ispLEVER Classic / Installation: What to do if error pops out when starting ispLEVER Classic "Can't read the ini file."?

2692 - Reveal: How do I get further detail for the "Failed to read design" error message in Reveal Inserter?

6822 - Lattice Diamond: Why does my design encounter a MAP error shown below when running the design flow?ERROR - <signal_name> matches no clock nets in the design.