1449 - Power Manager II: Can I program Hercules Demo Board using the USB cable provided with the kit?

 JTAG_SEL 
SW2 (3 2 1 0)

 MODE

 MASTER

 CHAIN

 1 0 1 0

 JTAG

 FTDI

 MachXO, POWR1220

 1 0 1 1

 JTAG

 FTDI

 MachXO, POWR1220, cPCI

 1 1 0 0

 JTAG

 FTDI

 MachXO

 1 1 0 1

 JTAG

 FTDI

 POWR1220

 1 1 1 0

 JTAG

 FTDI

 cPCI

 1 1 1 1

 I2C

 FTDI

 MachXO

• Related Articles

• 832 - Power Manager II: How to implement multiple POWR1220AT8 Power Manager devices on a board?

  There are several ways to do this. In some cases the functions inside a Power Manager II device may be stand alone and not affect the other device controlling other supplies. In the case where there are zones or sections that need to get powered up ...

• 280 - Power Manager II: How many I2C loads can I put on an I2C chain for Power Manager II devices?

  When using the Power Manager-II; POWR1220AT8, POWR1014A or POWR6AT6, it is important to know the loading and driving source of the full set-up. In a case where there are just a few I2C loads, whether Lattice POWR devices or others, the designer needs ...

• 7748 - Why is there a mismatch between the hardware checklist and the evaluation board circuit design?

  Description: The customer has observed discrepancies between the design recommendations provided in the Hardware Checklist and the actual design implementation on the Lattice Evaluation Board. Reason: Hardware Checklists are developed after ...

• 1749 - Power Manager II: How do I design a PCB land pattern for Power Manager to meet UL standards?

  Designing circuit boards to meet safety certification agency requirements is a very complex subject, and the requirements you need to meet also vary by product and geographical market. For example, two common requirements for PCB design are for for ...

• 5530 - Why is the Embedded VIP kit dual camera demo resets every after 4hrs?

  For all our demo boards/designs we have an internal counter that runs for about 4 hours, after that the demo with stop working. However, if the customer has bought these EVDK kits, then they should ask for a new license file for the ECP5 device so ...