1445 - PAC-Designer: Is there a I2C hardware verification utility available in the tool?

• Related Articles

• 1850 - PAC Designer: Does the PAC-Designer I2C utility work with the Lattice USB Download cable?

  The PAC-Designer I2C utility for the POWR1220AT8 device will work with the Lattice USB Download cable when using the WindowsXP operating system. It will not work with Windows7 operating system at this time. This utility was created so that a user ...

• 1895 - PAC Designer: How to change the I2C Address of the ISPPAC1014A device using the I2C Utility within PAC-Designer?

  Users cannot change the I2C address of the POWR1014A using the I2C utility. This only sets the address that gets used by the utility to communicate to the POWR1014A. The I2C address for the POWR1014A device is specified using the schematic sheet of ...

• 2751 - PAC Designer: Can I access the Platform Manager IN5 and IN6 CPLD inputs from I2C in a PAC-Designer logic design?

  Access for IN5 and IN6 from I2C is supported in PAC-Designer version 6.23 and later. The signals are available as inputs to the Boolean expression editor in the PAC-Designer logic view. The latest version of PAC-Designer is available at: ...

• 451 - PAC-Designer 5.2: Why does the tool fails to run and issues the following message? "C:\PAC-Designer52\PACD52.exe. This application has failed to start because the application configuration is incorrect. Reinstalling the application may fix the probl

  Solution: If reinstalling PAC-Designer 5.2 does not correct the problem, then the problem may be with the update status of the Windows operating system. Please have your IT department update the latest Windows drivers specifically the "dot-net" ...

• PAC-Designer: Which version of PAC-Designer supports ispClock 5500?

  PAC-Designer version 4.8 support ispClock 5520 and 5510. Here is the download link of the installer for Windows: https://www.latticesemi.com/view_document?document_id=21833 Please note that ispClock 5500 is already a discontinued product. ...