121 - How can I view the output IO waveform with IBIS model?
There are several ways to do that:
1. The typical usage of the IBIS file is to set up a simulation on an IBIS compatible simulator and have the IO output IBIS model drive a PCB trace with a receiver input attached at the end of the PCB trace, then view the waveforms.
2. User can use an IBIS model viewer such as the Hyperlinx Visual IBIS Editor to view the IBIS models for a specific load condition.
3. User can simulate the IBIS model with HSPICE / Hyperlinx.
Related Articles
1911 - How can I generate a much smaller IBIS model file that only includes the IO types defined in my project?
Situation: An IBIS model file from the Lattice web site includes all the programmable IO types a device can be set to, but the IBIS model file is very large and for some simulators, can slow the simulation setup time substantially. It is desired to ...
432 - How to get IBIS model for differential LVPECL IO when the generated model from ispLEVER is a single ended model?
The low voltage positive emitter couple logic (LVPECL) interface uses two separate single ended buffers, plus on-board resistors to emulate a differential pair. The input output buffer information standard (IBIS) requires that the models be ...
729 - IBIS Model: How do I find the output resistance of an I/O?
An IBIS Model is a mapping of voltage to current values for a given I/O standard, slew rate, and drive strength. User can estimate the output resistance by using a simple slope formula, in relative to the flow of current. Using Ohm's law: Resistance ...
2641 - In the Lattice IBIS files, the series resistance code of all IO type is 'a', which mean "off". I want to know in simlation, what resistance value should I set for output?
There are two ways to specify the output drivers. One is to specify series resistance, the other is to specify output current. Lattice IBIS models specify output current. They are equivalent. For example, 4mA is equivalent to 100ohms (0.4V(vol ...
1779 - LatticeECP3: Does Lattice provide IBIS model for SERDES inputs and outputs of LatticeECP3?
Currently Lattice does not provide LatticeECP3 IBIS model for SERDES input and outputs such as HDINP/N and HDOUTP/N. Alternatively, we recommended you use the LatticeECP3 HSPICE IO Kit to reach their simulation goals. The Lattice HSPICE IO Kit is ...