1129 - How many additional clocks are required after the bitstream is sent in with slave configuration modes?

• Related Articles

• 6954 - All Nexus Families: How are the commands and bitstream sent in the Nexus device via Quad (x4) Slave SPI?

  See below on how to send the commands in Quad (x4) SSPI mode in comparison to Standard(x1) SSPI mode 1.) See below comparison on how the commands are sent using Standard Slave SPI vs. Quad Slave SPI. In this example, the LSC_REFRESH (0x79) command ...

• 2714 - ICE40: What are the programming modes available in LatticeiCE40 device?

  The LatticeiCE40 device has the following programming modes : SPI Master: In this mode, a standard SPI Flash is connected to the Device , and the device boots from the external SPI Flash using SPI Master configuration Interface. This is the best ...

• 1974 - LatticeXP2: Why are padding bits required for every LatticeXP2 FPGA <b>except</b> the LatticeXP2-40 when it is programmed in Slave SPI mode?

  The LatticeXP2 configuration memory is arranged in an array. The array size varies depending on the number of logic elements available in the FPGA. The LatticeXP2 array dimensions are as follows: LatticeXP2-5: 1938 rows, each 638 bits wide ...

• 1766 - LatticeECP3: Is the LatticeECP3 SCM(Serial Configuration Mode) similar to&nbsp;LatticeECP2&nbsp;slave serial programming mode?

  Yes, the LatticeECP2 slave serial programming mode and the LatticeECP3 SCM modes are identical. Both modes use a simple 2-pin interface(CCLK and DIN). The details of these programming modes are described in the LatticeECP3 sysCONFIG Usage guide and ...

• How to enable SSPI programming in MachX03-9400 Development Board

  To enable SSPI programming, this is the generic checklist user should follow through: Enable SPI port in Diamond/Radiant Software Tools some device may have Slave SPI port enabled, but it is essential for user to cross-check their project to ensure ...