1032 - Lattice Diamond: Lattice ispLEVER:&nbsp;Can I open EPIC on a design that uses an IPCore that was downloaded from Lattice's website? <br>

• Related Articles

• Lattice Diamond: Why do i encounter a WARNING from my design relating to Diamond's Security feature?&nbsp;<div><br></div>

  Description: When user design is compiled (Synthesis --> Bitstream) a Warning shown below is encountered WARNING -Security project file open Error! Security feature is turned OFF! Solution: The warning is valid and is just providing message that the ...

• 2153 - ispLEVER to Diamond: error generated when migrating a schematic-based design?

  Description: The normal procedure to migrate a design to Lattice Diamond is by using the “Import ispLEVER Project..” option in the Lattice Design software. While importing, when you check “Copy design source to Implementation’s Source Directory”, all ...

• 1237 - Lattice ispLEVER: ispLEVER issued warning for a design with EBR in ASYNC Reset mode<br>

  Lattice ispLEVER: This is due to a hardware restriction and there is a possibility that you may destroy the memory content if this operation isn't performed properly. This is documented in LatticeECP2/M Family Data Sheet (DS1006.pdf, Page 2-20) and ...

• 1239 - Lattice ispLEVER: Lattice Diamond: Why do I get "invalid hex parity digit" errors with ispLEVER/Diamond bitgen?<br>

  Lattice ispLEVER: Lattice Diamond: This typically happens when you specify the Memory Initial Hex Value that is larger than the data-width of the Memory. All the Lattice EBR blocks need 18-bit initial data for each address location, but they ...

• 1043 - Diamond / Installation: How to manually update ispLEVER and Diamond software?<br>

  Solution: This describes how to manually update your software by using ispUpdate. For Lattice Diamond software, the "Update Center" is in the middle of your startup screen and will provide the most recent updates, if available. To manually check for ...